Rodeo S 2WD L4-2.2L (1999)
-
Install the rubber bushing by using installer J-39214.
NOTE: When mounting rubber bushings, be sure not to use grease on bushings or any other nearby part.
INSTALLATION
1. Install trailing link. Make sure that the trailing link is in its correct position.
NOTE: When mounting trailing link, be sure not to use grease on bushings or any other nearby part.
2. Install bolt, nut and protector. Tighten the bolts and nuts lightly, then retighten them to the specified torque after the vehicle is at curb height.
Torque to 137 Nm (101 ft. lbs.).
3. Install parking brake cable.
CAUTION: The parking brake cable should not be overstrained or slackened.
