Rodeo S 2WD L4-2.2L (1999)
-
Install the rubber bushing by using to installer J-43008.
NOTE: When mounting rubber bushings, be sure not to use grease on bushings or any other nearby part.
INSTALLATION
1. Install upper link. Make sure that the upper link is in its correct position.
NOTE: When mounting upper link, be sure not to use grease bushings or any other nearby part.
2. Install bolt, nut, rubber plate and protector. Tighten the bolts and nuts lightly, then retighten them to the specified torque after the vehicle is at curb
height. Torque to 137 Nm (101 ft. lbs.).
3. Install speed sensor cable.
4. Install fuel tank.
