Rodeo S 2WD L4-2.2L (1999)
12. Remove the rear trailing link front mount. See Figure 40 for reference.
a. Using a cutting wheel cut just below or through the weld to remove the bracket.
b. Use a disk grinder to remove any excess material and smooth out the frame.
13. Remove the frame plug from the driver and passenger side frame rails as shown in Figure 6. Discard the plug.
14. Using a hammer knock on the outside of the frame rail to loosen any rust on the inside of the frame.
15. Using a wire brush and scraper remove any loose coating material and rust from the entire outside frame rail. Clean the area 10 inches forward and
rearward the bracket location.
