Rodeo S 2WD L4-2.2L (1999)
8. Insert the long spray nozzle with NOXUDOL 700 into the side frame hole toward the front of the vehicle up to the 300mm (12 inches) mark. Then
spray NOXUDOL 700 while drawing out the nozzle. Spray four times. See Figure 10.
9. Insert long spray nozzle with NOXUDOL 700 into the side frame hole toward the rear of the vehicle up to the 200m (7 inches) mark. Then spray
NOXUDOL 700 while drawing out the nozzle. Spray four times. See Figure 11.
10. Insert long spray nozzle with NOXUDOL 700 through the side frame hole up and down. See Figures 12 and 13. Then spray NOXUDOL 700 with
drawing out the nozzle. Spray two times in each direction.
11. Switch from the long spray nozzle to the short spray valve shown in Figure 7 and spray one coat of Noxudol 700 onto the outside of both driver and
passenger side in the area indicated in Figure 4. Be careful not to overspray onto the exhaust system or body painted areas.
12. Using the short spray nozzle spray Noxudol 300 onto both driver and passenger side as indicated in Figures 4 and 5. Be careful not to overspray
onto the exhaust system or body painted areas.
13. Install the side frame hole plug. If the plugs locking tabs were damaged during removal or are missing/replace it (P/N 8-97175-885-0).
14. Apply the campaign label (see "Applying the Campaign Label" in this bulletin).
Condition Three: Reinforcement Bracket Type "A" Installation
1. Remove the Rear Trailing Link Front Mount mounting nut from both driver and passenger side. See Figure 15.
2. Remove lower half of body mount #4 from both driver and passenger side. See Figures 15 and 16.
