Rodeo S 2WD L4-2.2L (1999)
17.
Tear off the corner of a business card or some other suitable material approximately .010 mm thick (feeler/wire gauge). Insert the card piece
between the cable slider and the interlock pin (figure 10).
18.
Pry out the adjuster clip, then snap it back into place. Remove the card piece (feeler/wire gauge) make sure the ignition switch turns to LOCK,
then press firmly on the shift lever push-button and pull down on the shift lever to make sure the lever is locked in "P" position.
19.
Plug in the accessory power outlet connectors and reinstall the front console.
20.
On 4WD models, reinstall the transfer control lever knob.
21.
Plug in the POWER and WINTER switch connectors and reinstall the rear console.
22.
Move the shift lever to the "L" position, plug in the cigarette lighter connectors and reinstall the lower cluster assembly.
23.
Reinstall the upper and lower steering column cover.
24.
Reinstall the driver's dashboard lower cover.
25.
Reinstall the driver's kick panel.
