Rodeo S 2WD L4-2.2L (1999)
10.
Remove the seven case housing bolts at the outer ring, not the 5 inner bolts (see figure 2).
11.
Lift the converter housing and oil pump assembly straight up. Set the assembly on the bench with the pump side up (see figure 3).
12.
Replace the case 0-ring and gasket (8-96017-189-0 0-ring & 8-96014-973-0 gasket) (see figure 4).
13.
Wet the new gasket and 0-ring with DEXRON(R)-III with a G-License Number (G-XXXX) (refer to bulletin 1B03-05-S001 4L30E/4L60E
Transmission Fluid) (see figure 5).
14.
Line-up the case holes with the gasket and install the 0-ring without twisting it.
15.
Use ONLY petroleum jelly to hold the selective thrust washer in place.
