Rodeo S 2WD L4-2.2L (1999)
16.
Replace the turbine shaft scarf-cut plastic seals (8-96017-484-0 scarf seals 2x) (see figure 6).
17.
Apply petroleum jelly in the seal groves to hold the new seals in place.
Note:
Be sure the angled cut ends are properly matched or the new seals will not seal properly.
18.
Grab the turbine shaft and lift out the 4th clutch, 4th retainer, & overrun assembly (Figure 7).
19.
Remove the remaining steel 4th clutch plate (see figure 8).
20.
Remove the overdrive internal gear and thrust bearing (see figure 9).
21.
Remove the thrust washer
