isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Radio - Excessive Static|Page 2682 > < Radio - Excessive Static
Page 2
background image

If resistance is over 1.0 ohm, corrcct the antenna ground point located EITHER behind thc right kick panel (Figure 3) or under the right fender well
(Figure 4). Clean and tighten the ground point as necessary.

3.

Install a new radio ground wire (listed in "Parts Information" section of this Service Bulletin) as follows:

a.

Remove the four screws securing the air conditioner/heater control panel (Figure 5). Do not remove the control panel at this time.

b.

Remove the 6 mm nut attached to the stud bolt behind the ashtray area (Figure 5).

Radio - Excessive Static|Page 2682 > < Radio - Excessive Static