Trooper LS V6-3.5L (1998)
11. Remove connecting rod caps.
12. Remove crankshaft main bearing caps.
13. Remove crankshaft and main bearings.
INSTALLATION
1. Install crankshaft and main bearings.
-
Install main bearing in the cylinder block and main bearing cap respectively.
Apply new engine oil to upper and lower main bearings.
NOTE:
^
Do not apply engine oil to the bearing back faces.
^
Make sure that main bearings are in correct position.
^
Install crankshaft with care.
^
Apply engine oil to the thrust washer.
^
Install thrust washer on No.3 journal.
^
Oil grooves in thrust washer must face the crankshaft.
2. Install crankshaft main bearing caps.
-
Apply engine oil to the thread and seating surface of each bearing cap fixing bolt.
NOTE:
^
Do not apply engine oil to the bearing back faces.
^
Install bearing caps in the order of numbers, starting with cylinder block front side.
^
Tighten main bearing fixing bolts to the specified torque.
Torque: 39 Nm (29 ft. lbs.)
^
After tightening the bolts, make sure that the crankshaft rotates smoothly.
3. Install connecting rod caps.
-
The cap number must be same as connecting rod number.
-
Apply engine oil to the thread and seating surface of each nut.
-
Tighten nuts to the specified torque.
Torque: 54 Nm (40 ft. lbs.)
-
After tightening the nuts, make sure that the crankshaft rotates smoothly.