Trooper LS V6-3.5L (1998)
4. Install rear oil seal retainer.
-
Remove oil on cylinder block and retainer fitting surface.
-
Apply sealant (TB1207B or equivalent) to retainer fitting surface as shown in illustration.
-
The oil seal retainer must be installed within 5 minutes after sealant application before the sealant hardens.
-
Apply engine oil to oil seal lip and align a dowel pin hole in the cylinder block with that in the retainer.
-
Tighten retainer fixing bolts to the specified torque.
Torque: 18 Nm (13 ft. lbs.)
5. Install flywheel.
-
Clean tapped holes in the crankshaft.
-
Remove oil on crankshaft and flywheel fitting surface.
NOTE:
^
Do not reuse the bolts.
^
Do not apply oil or thread lock to the bolts.
