Trooper LS V6-3.5L (1998)
-
Tighten fixing bolts to the specified torque.
Torque: 54 Nm (40 ft. lbs.)
6. Install oil gallery.
-
Clean contact surface of oil gallery and main bearing cap.
Apply engine oil to oil gallery fixing bolts and tighten the bolts in two steps, in the order shown in illustration.
Torque:
1st step: 29 Nm (21 ft. lbs.)
2nd step: 55° - 65°
7. Install cylinder body side bolts and tighten bolts in order to the specified torque.
Torque: 39 Nm (29 ft. lbs.)
NOTE: Do not apply the oil to the bolts.
8. Install oil pump assembly.
-
Remove oil on cylinder block and oil pump mounting surface.
-
Apply sealant (TB1207B or equivalent) to the oil pump mounting surface.
-
The oil pump assembly must be installed within 5 minutes after sealant application before the sealant hardens.
-
Apply engine oil to oil seal lip.
-
Install oil pump in the cylinder block and tighten fixing bolts to the specified torque.
