Trooper LS V6-3.5L (1998)
Compressor Clutch Bearing: Service and Repair
Removal
1. Remove the clutch plate and hub assembly as described previously.
2. Remove rotor (1) and bearing assembly retaining ring (2), using snap ring pliers.
3. Install pulley rotor and bearing puller guide J-33023-A to the front head and install J-41552 pulley rotor and bearing puller down into the inner
circle of slots (1) in the rotor. Turn the J-41552 puller clockwise in the slots in the rotor.
4. Hold the J-41552 puller in place and tighten the puller screw against the puller guide to remove the pulley rotor and bearing assembly.
Installation
1. With the compressor mounted to the J-34992 holding fixture, position the rotor and bearing assembly on the front head.
2. Position the J-33017 pulley, rotor and bearing installer and J-33023-A puller pilot directly over the inner race of the bearing.
3. Position puller crossbar J-8433-1 on the puller pilot J-33023-A and assemble the two J-33026 through bolts and washers through the puller bar
slots and thread them into the J-33026 holding fixture. The thread of the through bolts should engage the full thickness of the holding fixture.