Trooper LS V6-3.5L (1998)
4. Tighten the center screw in the J-8433-1 puller crossbar to force the pulley rotor (1) and bearing assembly onto the compressor front head. Should
the J-33017 pulley rotor and bearing installer slip off direct in-line contact with the inner race of the bearing, loosen the J-8433-1 center forcing
screw and realign the installer and pilot so that the J-33017 installer will properly clear the front head.
5. Install rotor and bearing assembly retainer ring, using snap ring pliers.
6. Reinstall clutch plate and hub assembly.