Trooper LS V6-3.5L (1998)
3. Measure the clearance between slave cylinder wall and piston.
4. If the measured value exceeds the specified limit, the slave cylinder assembly must be replaced.
Standard: 0.07 mm (0.0028 inch)
Limit: 0.15 mm (0.0059 inch)
REASSEMBLY
To reassemble, follow the disassembly steps in the reverse order, noting the following points:
1. Before installing the parts, apply a thin coat of rubber grease.
2. Install cup in groove in piston with the lip turned to the front of cylinder. Use care so as not to scratch the cylinder.
