VehiCROSS 4WD V6-3.5L (1999)
2. Remove air bag assembly from steering wheel by removing two bolts. Lift air bag assembly out of steering wheel.
3. Disconnect connector and remove air bag assembly.
4. Disconnect horn lead.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Connect air bag to wiring harness connector.
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air bag to prevent lead wire from being pinched.
2. Connect horn lead.
3. Install air bag into steering wheel and tighten bolts to specified sequence as shown in figure.
Torque: 8.8 Nm (78 lb.in)
CAUTION: Never use the air bag assembly from another vehicle. Use only the air bag assembly for Vehi CROSS (VX).
4. Enable the Supplemental Restraint System (SRS).