VehiCROSS 4WD V6-3.5L (1999)
Air Bag: Service and Repair
Passenger Air Bag Assembly
SRS Connectors (2 Pin)
SRS CONNECTORS (2 PIN)
CAUTION: The special yellow color connectors are used for supplemental restraint system-air bag circuit. When removing the cable harness, do not
pull the cables. Otherwise, cable disconnection may occur. When connect the SRS connector, insert the connector completely. Imperfect locking may
cause malfunction of SRS circuit.
SRS Connectors (3 Pin)
SRS CONNECTORS (3 PIN)
CAUTION: Double-lock type yellow color connectors are used for supplemental restraint system-air bag circuit.
When removing the cable harness, disconnect the connector by unlocking at two places, outside (1) and inside (2). In such a case, do not pull the
wires. Otherwise, wire disconnection may occur.
When connect the double lock type SRS connector, insert the connector completely and lock at outside. Imperfect locking may cause malfunction of
SRS circuit.
Airbag Deployment and Disposal (Inside Vehicle)
Deployment inside vehicle is proper when the vehicle is to be destroyed or salvaged for component parts. This includes, but is not limited to, the
following situations:
The vehicle has completed its useful life.
The vehicle has been damaged beyond repair in a non deployment type accident.
The vehicle has been stripped or damaged beyond repair in a theft.
The vehicle will be salvaged for component parts to be used on a vehicle with a different Vehicle Identification Number (VIN) as opposed to being
rebuilt as same VIN. Never use SRS components from another vehicle.
WARNING: FAILURE TO FOLLOW PROPER SRS AIR BAG ASSEMBLY DISPOSAL PROCEDURES CAN RESULT IN AIR BAG
DEPLOYMENT WHICH MAY CAUSE PERSONAL INJURY. UNDEPLOYED AIR BAG ASSEMBLIES MUST NOT BE DISPOSED OF
THROUGH NORMAL REFUSE CHANNELS.THE UNDEPLOYED AIR BAG ASSEMBLY CONTAINS SUBSTANCES THAT CAN CAUSE
SEVERE ILLNESS OR PERSONAL INJURY IF THE SEALED CONTAINER IS DAMAGED DURING DISPOSAL.DISPOSAL IN ANY
MANNER INCONSISTENT WITH PROPER PROCEDURES MAY BE A VIOLATION OF FEDERAL, STATE AND/OR LOCAL LAWS.
1. Turn ignition switch to "LOCK", remove key and put on safety glasses.
2. Remove all loose objects from front seats.
3. Disconnect Supplemental Restraint System (SRS) coil assembly, yellow 2-pin connector located at the base of the steering column.
4. Cut the SRS coil assembly yellow 2-pin harness connector from the vehicle leaving at least 16 cm (six inches) of wire at the connector.
5. Strip 13 mm (1/2 inch) of insulation from yellow-green and yellow-black wire lead of the connector.
6. Cut two 900 cm (30 feet) deployment wires from 0.8 sq.mm (18 gauge) or thicker multi-strand wire. These wires will be used to fabricate the
driver deployment harness.
7. Strip 13 mm (1/2 inch) of insulation from both ends of the wires cut in the previous step.
