S-Type (X200) V8-4.2L (2005)
Air Door Actuator / Motor: Service and Repair
Floor Door Actuator
Footwell Vent/Duct Blend Door Actuator (82.20.85)
Removal
All vehicles
1. Disconnect the battery ground cable.
2. Remove the front footwell duct left-hand.
Left-hand drive vehicles
1. Reposition the in-vehicle temperature sensor venturi pipe.
All vehicles
1. Remove the footwell vent/duct blend door actuator.
-
Disconnect the electrical connector.
-
Remove the retaining bolts.
-
Remove the footwell vent/duct blend door actuator.
Installation
1. To install, reverse the removal procedure.
NOTE: During installation make sure the actuator is fully meshed with the driven flap before tightening the bolts.