Vanden Plas (X308) V8-4.0L (AJ27) (2000)
/v8-4.0l_(aj27)/Page-1191016.png)
2. Slacken and remove the two front nuts and two rear screws securing the retaining panel.
3. Position retaining panel for access, disconnect SPORT mode and cruise control ON/OFF switch multiplugs and remove retaining panel complete
with switches.
4. Remove switches from retaining panel.
5. Remove and discard bushes from retaining panel.
Installation
1. Fit and fully seat new bushes in retaining panel.
2. Fit and fully seat SPORT mode and cruise control ON/OFF switches in retaining panel.
3. Position retaining panel for access and connect SPORT mode and cruise control ON/OFF switch multiplugs.
4. Fully seat retaining panel and fit and tighten securing nuts and screws.
