Vanden Plas (X308) V8-4.0L (AJ27) (2000)
25. Power seat fully forward and rearward ensuring satisfactory operation.
26. Return seat to original position.
Front Seat Head Restraint Motor
Front Seat Head Restraint Motor (86.75.17)
Removal
1. Power seat fully forward and position squab in fully upright position.
2. Remove front seat back finisher.
3. Remove battery cover and disconnect ground cable from battery terminal.
4. Release and remove seat tensioner spring.
5. Slacken and remove headrest motor securing screws and remove drive cable retaining plate.
6. Withdraw drive cable from motor.
7. Release motor harness multiplug (yellow) from mounting bracket, position motor for access and disconnect multiplug.
8. Remove headrest motor from seat.
Installation
1. Position motor in seat frame, connect harness multiplug and seat multiplug in mounting bracket.
2. Install motor on headrest drive cable and align with mounting bracket.
3. Fit motor securing screws and drive cable retaining plate.
4. Tighten motor securing screws.
5. Install seat tensioner spring.
6. Fit seat back finisher.
7. Connect ground cable to battery terminal and fit battery cover.
Front Seat Headrest Motor
Removal
1. Power seat fully forward and position squab in fully upright position.
2. Remove front seat back finisher. See: Seat Back/Service and Repair
3. Remove battery cover and disconnect ground cable from battery terminal. See: Starting and Charging/Battery/Battery Cable/Negative/Service and