Commander 4WD V8-4.7L VIN N (2006)
8. Lubricate caliper mounting bolt bushings, boot seals and bores with Mopar brake grease or Dow Corning G407 grease only.
CAUTION: Use of alternative grease may cause damage to the boots seals.
9. Install the boot seals into the caliper seal bores and center the seals in the bores.
10. Install mounting bolt bushings into the boot seals and insure seal lip is engaged into the bushing grooves at either end of the bushing.
11. Install caliper bleed screw.
INSTALLATION
1. Install the caliper (5) on the adapter (2).
2. Caliper slide pins should be free from debris and lightly lubricated..
3. Install the caliper slide pin bolts (2) and tighten to 44 Nm (32 ft. lbs.).
4. Gently lift one end of the slide pin boot to equalize air pressure, then release the boot and verify that the boot is fully covering the slide pin.
CAUTION: Verify brake hose is not twisted or kinked before tightening banjo bolt.
5. Install brake hose (5) to caliper (1) with new copper washers (6) and tighten banjo bolt (6) to 31 Nm (23 ft. lbs.).
6. Fill and bleed brake system.
7. Install wheel and tire assemblies.
8. Remove supports and lower vehicle.
9. Verify brake fluid level.
Disc Brake Caliper Adapter
DISC BRAKE CALIPER ADAPTER
REMOVAL
