Commander 4WD V8-4.7L VIN N (2006)
3. Connect the receiver/drier inlet tube (6) to the A/C condenser (2).
4. Tighten the screw (3) that secures the receiver/ drier (4) to the radiator and fan shroud (5). Tighten the screw to 5 N.m (44 in. lbs.).
5. Connect the A/C discharge line (1) to the A/C condenser.
6. Remove the tape or plugs from the automatic transmission cooler line fittings and the fluid cooler ports.
7. Connect the automatic transmission cooler lines (1) to the transmission fluid cooler (2).
8. Install the power steering fluid cooler.
9. Install the upper radiator crossmember and support bracket.
10. Install the air filter housing and air inlet tube.
11. Install the grille.
12. Reconnect the negative battery cable.
13. Evacuate the refrigerant system.
14. Charge the refrigerant system.
15. Check the automatic transmission fluid level. Fill as required.
