Commander 4WD V8-4.7L VIN N (2006)
2.
From the rear of the vehicle, move the seat belt away from the plastic seat belt trim cover on the seat back and remove the two screws (Figure 1).
3.
Using a trim stick, gently pry up the seat belt trim cover at both rear corners.
4.
Remove the seat belt trim cover.
5.
Gently pull back on the seat back cover fabric to expose the seat belt metal bracket (Figure 2).
6.
Insert the plastic bracket cover between the seat back fabric and the seat back plastic bolster (Figure 2).
7.
Slide the plastic bracket cover rearward and tuck the front corners of the plastic bracket cover underneath the seat back plastic bolster as shown in
Figure 3.
