Commander 4WD V8-4.7L VIN N (2006)
8.
Slide the plastic bracket cover forward until seated. The two threaded screw holes for the seat belt trim cover should be centered in the opening of
plastic bracket cover.
9.
Install the seat belt trim cover.
10.
Install the two screws for the seat belt trim cover.
11.
Repeat Steps 1 through 10 for the other seat belt.
B. Seat Belt Replacement
NOTE:
Only those seat belts that are frayed at the edges, as determined by the inspection in Section "A" require replacement. Very few vehicles are expected
to require seat belt replacement.
1.
Using the chart below, order the correct seat belt part number.
THIRD ROW OUTBOARD SEAT BELT PART NUMBER TABLE
2.
Remove cargo storage bin lid.
3.
Remove the lift gate scuff plate.
4.
Remove the two nuts securing the cargo storage bin.
5.
Remove the cargo storage bin from the vehicle and set it aside.
6.
Remove the center bolt between the seat bottom frame. (Figure 4)
7.
Remove the two outer nuts from the seat bottom frame. (Figure 4)
8.
Lift the seat assembly up off the rear studs and release the front hooks from the strikers. (Figure 4)
9.
Remove the seat from the vehicle and place it on a clean work surface.
