Commander 4WD V8-4.7L VIN N (2006)
10.
Remove the bolt holding the seat belt lower anchor to the outboard rear corner of the third row seat support bracket. (Figure 5)
11.
Move the seat belt away from the plastic seat belt trim cover and remove the two screws (Figure 1).
12.
Using a trim stick, gently pry up the seat belt trim cover at both rear corners.
13.
Remove the seat belt trim cover.
14.
Remove the screw for the seat pivot trim cover and remove cover (Figure 5).
15.
Remove the plastic trim for the seat back latch loop located on the outboard side near the top.
16.
Remove the grocery bag hook panel from the seat back.
17.
Using a suitable tool, separate the plastic fasteners holding the seat back trim panel to the seat back as follows:
a.
along the inboard side, four fasteners
b.
along the bottom side, two fasteners
c.
along the outboard side, three fasteners
Do not separate the upper two middle and center panel fasteners.
NOTE:
Do not pull on the seat back panel to remove. The fasteners may pull through the seatback panel fiber board and damage the panel.
18.
Holding the edge of the back trim panel, push upward and then pull out to release the three remaining fasteners.
19.
Peel back the fabric on the bottom of the head rest and release the head rest from its stanchions. Place the head rest on a clean surface.
20.
Unhook the inboard, outboard, and top seat back fabric from the seat back frame.
21.
From the back of the seat, push the fabric upwards over the seat frame top.
22.
Peel the seatback fabric and foam cushion from the front of the seat back frame.
23.
Remove the two screws holding the plastic bolster and remove bolster.
24.
Remove the retractor bolt that secures the retractor retainer bracket to the top of the retractor pocket on the front upper outboard corner of the seat
back frame (Figure 6).
25.
Remove the retractor retainer bracket from the top of the retractor pocket on the seat back frame (Figure 6).
