Commander 4WD V8-4.7L VIN N (2006)
3. Raise the vehicle on a hoist.
4. Install the battery wire harness retaining clips (7) & (9) to the engine.
5. Reconnect the battery wire harness connector (2) to the connector receptacle on the starter solenoid.
6. Install the battery positive cable eyelet terminal (3) onto the B(+) terminal stud on the starter solenoid.
7. Install and tighten the nut (4) that secures the battery positive cable eyelet terminal (3) to the B(+) terminal stud on the starter solenoid. Tighten the
nut to 11 N.m (95 in. lbs.).
8. Install and tighten the bolt (5) that secures the battery negative cable ground eyelet terminal (6) to the engine block (10). Tighten the bolt to 11
N.m (95 in. lbs.).
9. Lower the vehicle.
10. Install the battery wire harness retaining clips (2) to the valve cover studs.
11. On 5.7L engines, reconnect the battery wire harness connector (6) to the generator field terminal connector receptacle on the back of the generator.
12. Install the generator output cable eyelet terminal (4) onto the generator output terminal stud.
13. Install and tighten the nut (5) that secures the generator output cable eyelet terminal (4) to the generator output terminal stud. Tighten the nut to 14
N.m (125 in. lbs.).
