Commander 4WD V8-4.7L VIN N (2006)
20. Raise the vehicle on a hoist.
21. Remove the bolt (5) that secures the battery negative cable ground eyelet terminal (6) to the engine block (10).
22. Remove the nut (4) that secures the battery positive cable eyelet terminal (3) to the B(+) terminal stud on the starter solenoid.
23. Remove the battery positive cable eyelet terminal from the B(+) terminal stud on the starter solenoid.
24. Disconnect the battery wire harness connector (2) from the connector receptacle on the starter solenoid.
25. Remove the battery wire harness retaining clips (7) & (9) from the engine.
26. Remove the battery wire harness from the engine compartment.
INSTALLATION
NOTE: Both the battery negative cable and the battery positive cable are serviced in the battery wire harness. If either battery cable is damaged or
inoperative, the battery wire harness assembly must be replaced.
1. Clean and inspect the battery cable terminal clamps and the battery terminal posts.
2. Position the battery wire harness assembly (10) into the vehicle.
