Liberty 4WD V6-3.7L (2009)
Vehicle Lifting: Service and Repair
HOISTING
Refer to the Owner's Manual for emergency vehicle lifting procedures.
When properly positioned, a floor jack can be used to lift the vehicle. Support the vehicle in the raised position with jack stands at the front and rear ends
of the frame rails.
CAUTION: Do not attempt to lift the vehicle with a floor jack positioned under:
-
A body side sill.
-
A steering linkage component.
-
A drive shaft.
-
The engine or transmission oil pan.
-
The fuel tank.
-
A front suspension arm.
-
Transfer case.
NOTE: Use the correct sub-frame rail or frame rail lifting locations only.
HOIST
Refer to the Owner's Manual for emergency vehicle lifting procedures.
A vehicle can be lifted with:
-
A single-post, frame-contact hoist.
-
A twin-post, chassis hoist.
-
A ramp-type, drive-on hoist.
NOTE: When a frame-contact type hoist is used, verify that the lifting pads are positioned properly.
WARNING: The hoisting and jack lifting points provided are for a complete vehicle. When a chassis or drivetrain component is removed from
a vehicle, the center of gravity is altered making some hoisting conditions unstable. Properly support or secure vehicle to hoisting
device when these conditions exist.