Borrego 2WD V6-3.8L (2009)
2. Install the upper return spring (C) and the brake shoes (D).
3. Install the adjuster assembly (B) and the lower return spring (A).
4. Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.
5. Install the parking brake cable (B), then install the clip (A).
6. Install the rear brake disc, then adjust the rear brake shoe clearance.
(1) Remove the plug from the disc.
(2) Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.
7. Install the brake caliper assembly.
8. Install the tire and wheel.
