Optima V6-2.7L (2003)
Tighten mounting screws to 69 - 95 lb-in (8 - 11 N.m, 80 - 110 kg-cm)
3. Install one screw on rod cover of inside handle.
4. Install two mounting nuts on door lock actuator.
5. Connect two remote control rods on outside handle.
6. Connect door lock actuator connector.
3. Install plastic door screen.
1. Fasten plastic door screen.
2. Pull out electrical harness connector from plastic door screen.
3. Pull out remote control rod for inside door handle from plastic door screen.
4. Install pull handle bracket with two mounting screws.
5. Install inside door handle assembly.
1. Install two mounting screws.
2. Connect two remote control rods of door lock assembly.
6. Install door trim. Refer to "Trim".
7. Connect negative battery cable.