Air Bag Deployment and Disposal - Service and Repair | Rio L4-16L (2004)
IN AN OPEN AREA TO PREVENT FIRES. ALLOW COMPONENTS AT LEAST TWENTY MINUTES TO THOROUGHLY COOL.
COOLING MODULES SHOULD BE CONTINUOUSLY MONITORED TO ENSURE HOT COMPONENTS DO NOT CREATE FIRES
WITH SPILLED LIQUIDS OR OTHER DEBRIS. FAILURE TO ALLOW UNIT TO COOL COULD RESULT IN BURNS, FIRES OR
PERSONAL INJURY.
-
ALWAYS WEAR RUBBER GLOVES AND SAFETY GLASSES WHEN HANDLING A DEPLOYED AIRBAG MODULE.
CAUTION: Storage, transportation, disposal and recycling of airbag module and components must be performed in accordance with all applicable state
and local regulations including, but not limited to, environmental protection, occupational health and safety, and transportation.
WARNING: FAILURE TO FOLLOW THE FOLLOWING PROCEDURES COULD RESULT IN PERSONAL INJURY OR DEATH.
1. Remove battery.
2. Wait 10 minutes before proceeding.
3. Disconnect appropriate Airbag Module, and remove from vehicle. For Driver airbag module, refer to Air Bag Module. For Passenger Airbag
Module, refer to Passenger Air Bag Module.
4. Locate airbag in an area that will provide protection to personnel when it deploys. An example of a safe deployment site is a stack of used tires,
6-8 high, with undeployed bag located inside column of tires.
5. Connect the Air Bag Deployment Tool (k95U-6000-BDY) to the Air Bag Module connector, and position the deployment tool 20 feet away from
the deployment site.
6. Connect the red lead to the positive terminal of the battery.
7. Connect the black lead to the negative battery terminal.
