Rio L4-16L (2004) - Front Wheel Bearing Service and Repair
2. Install wheel speed sensor (for ABS).
3. Install the backing plate.
4. Install the spindle attaching nuts.
Tightening torque: 32 - 45 ft. lbs. (43 - 61 Nm, 4.4 - 6.2 kg-m)
5. Tighten the wheel speed sensor (for ABS).
Tightening torque: 13 - 19 ft. lbs. (17.6 - 26.5 Nm, 1.8 - 2.7 kg-m)
6. Install the rear brake assembly and brake pipe.
7. Install the outer bearing race by using a hammer.
Notice: Tap in until the outer race is fully seated in the hub.
8. Position the inner bearing in the bearing hub.
9. Lubricate the oil seal lip with a lithium grease.
10. Install an oil seal.
11. Install the sensor rotor by using a flat plate to press it in (For ABS).
Notice:
^
Use a new oil seal, and coat the lip with grease in the middle of the right halfshaft.
^
Do not hit the oil seal directly with a hammer.