Rio5 L4-1.6L (2006)
^
When installing a bearing assembly, always use a new one.
^
The right and the left bearings must be replaced as a matched set.
3. Using a plastic hammer, install the dust cover.
4. Press-in the hub to the knuckle.
Press fit load: 20 - 25 KN (2000 - 2500 kgf)
NOTE: Press-in the inner race of the wheel bearing to prevent damage to the bearing assembly.
5. Tighten the hub and the knuckle to the specified torque using the Special Tool (09517-21500).
Specified torque Nm (kgf-m, ft. lbs.): 200 - 260 (20 - 26, 144 - 188)
6. Measure the hub bearing starting torque.
Hub bearing starting torque [Limit] 1.3 Nm (13 kgf-m, 0.94 ft. lbs.) or less
7. If the starting torque is 0 Nm (0 kg-cm, 0 ft. lbs.), measure the hub bearing axial play.
