Rio5 L4-1.6L (2006)
CAUTION: Be careful not to damage the boot.
INSPECTION
1. Check the drive shaft spline for wear or damage.
2. Check that there is no water or foreign material in the BJ.
3. Check the spider assembly for roller rotation, wear or corrosion.
4. Check the groove inside the UTJ case for wear or corrosion.
5. Check the dynamic damper for damage or cracks.
REASSEMBLY
1. Wrap tape around the drive shaft splines (UTJ side) to prevent damage to the boots.
2. Apply grease to the joint (BJ) boot on the side of wheel and install the boots.
3. Install the bands to both boots.
4. Using clamp, secure the boot bands.
Clearance (A): 2.0 mm (0.079 inch) or less
5. To install the dynamic damper, keep the BJ shaft in a straight line and secure the dynamic damper with the dynamic damper bands.
Standard value mm (inch): 1.6 GSL: 405.0 ± 3 (15.94 ± 0.118)
