Sedona V6-3.8L (2009)
8. Support the REAR of the subframe with a Screw Jack. Remove the 2 small bolts and the large bolt from both rear corner stays.
9. With the Screw Jack, lower the rear of the subframe to get at least 1 inch of clearance between the subframe and the body peg
Remove the Upper Stopper.
Proceed to Removing The Subframe Bushing procedure.
Afterwards, if replacing the front bushings, loosely install rear
bushing bolts and remove corner stays and front bushing bolts.
Service Procedure Removing The Subframe Bushing
The Kia Subframe Bushing Remover and Installer will need to
be configured according to the illustration for Removing The
Subframe Bushing.
1. Lift the assembly into place placing the rod through the center of the bushing.
Thread the nut on the top of the threaded rod.
