Sedona V6-3.8L (2009)
Make sure the tool sets squarely around the bushing flange and on the subframe.
Hand tighten the nuts until the assembly is held in place.
2. Using hand tools, tighten the lower nut to remove the bushing.
If the bushing does not begin moving after applying pressure,
tap the side of the subframe with a hammer.
If the rubber separates from the outer sleeve, continue
removal with the procedure below under "Removing Outer Sleeve".
Otherwise, skip the next section and continue to the "Install
New Subframe Bushing" instructions.
Service Procedure Removing The Outer Sleeve
