Sephia GS Sedan L4-1.8L (1997)
3. Remove the glass by separating the glass from the sealant using a commercial power or manually operated removal tool, or use the following
procedure:
1. Use an awl to make a hole in the sealant.
2. Pass the end ot a 16 in (40 cm) length of piano wire through the hole, and attach suitable grips to both ends.
4. Two people should hold the grips, one inside and one outside the vehicle, and then "saw" the sealant from around the glass.
5. Remove the glass from the body.
NOTICE
When cutting the sealant from The bottom of the glass place a plastic sheet under The piano wire where it touches the instrument panel. Move The
plastic along as The sealant is cut.
NOTICE
-
Cut along the border between The glass and the sealant.
-
If too much heat develops, The piano wire may break. Cool it occasionally or don't work in one place too long.
-
If The glass is not to be reused, a tool like that shown in The figure is faster than piano wire.
INSTALLATION
1. Use a knife to smoothly trim the sealant on the body. Leave a layer about 0.04 to 0.08 in (1 or 2 mm) thick.
2. Carefully clean a 2.0 in (5 cm) wide area around the perimeter of the glass and the corresponding area on the body.
