Spectra L4-2.0L (2004)
1. Raise the vehicle unit the front tires are off the floor.
- Make sure the wheels are in a straight forward position.
NOTE: Make sure the wheel rotates freely and that the brake pads are retraced sufficiently to allow free movement of the tire and wheel
assembly.
Spin the tire by hand to check the wheel bearings for roughness.
2. Grip each front tire at the top and bottom and move the wheel inward and outward while lifting the weight of the tire off the front wheel bearings.
3. If the tire and wheel (hub) is loose on the spindle, does not rotate freely, or has a rough feeling when spun, carry out one of the following.
On vehicles with inner and outer bearings, inspect the bearings and races for wear or damage. Adjust or install new bearing and races as necessary.
4. Check the hub for cracks and the splines for wear.
5. Check the brake disc for scoring and damage.
6. Check the knuckle for cracks.
7. Check the bearing for cracks or damage.
REASSEMBLY
1. Apply multi - purpose grease to the contacting surface of the knuckle hub and bearing thinly.
2. Using the Special Tool (09532-11500), press - in the bearing to the knuckle.
a. Install the snap ring.
NOTE:
-
Press - in the outer race of the wheel bearing to prevent damage to the bearing assembly.
-
When installing a bearing assembly, always use a new one.
-
The right and the left bearings must be replaced as a matched set.
