Sportage 4WD L4-2.0L (2005)
Control Module: Customer Interest
A/T Controls - MIL ON/DTC P0736 Set
Model: Spectra, Sportage
Group: Automatic Transaxle(52)
Number: KT2006020802
Date: Wednesday, February 01, 2006
Area: N. America
Subject
2005MY 2.0L Sportage/Spectra TCM
Reprogramming (TSB - Trans/driveline - 015)
Description
This bulletin provides information relating to a repair for 2005MY Spectra and Sportage automatic transmission equipped vehicles with 2.0L engines.
Some 2005 2.0L equipped Spectra and Sportage vehicles may turn on the MIL with DTC P0736 (Reverse Gear Incorrect Ratio) stored without any
system fault.
This bulletin describes the procedure for upgrading the TCM software with new logic to correct this condition.
Effective Vehicle Information
AFFECTED PRODUCTION RANGE:
2005MY Spectra and Sportage automatic transaxle equipped vehicles with 2.0L engines.
Service Procedure
ROM ID INFORMATION TABLE:
Download the latest Hi-Scan Pro reprogramming software for the 32MB (blue label) reprogramming card from the Kia Service Information System
(KSIS). Click on the downloads link located in the News Center on the KSIS Home Page.
* NOTICE
^
A fully charged battery is necessary before reprogramming can take place. DO NOT connect a battery charger to the vehicle during reprogramming.
Make sure the blower motor is "OFF" during programming.
^
All reprogramming must be done with the ignition key in the "ON" position.
^
Be careful not to disconnect any cables connected to the vehicle or Hi-Scan Pro during the reprogramming procedure.
^
DO NOT start the engine during reprogramming.
^
DO NOT turn the ignition key "OFF" or interrupt the power supply during reprogramming.
^
When the reprogramming is completed, turn the ignition key "OFF" and wait 20 seconds before starting the engine.
