Lancia common faults and how to fix them
Faults that are well known on Lancia models we hold manuals for: what the owner notices, what causes it, and the pages in our manuals that cover the repair.
- Lancia Thesis electric parking brake: EPB failure warning
- Lancia Thesis battery drain: flat battery after standing
- Lancia Thesis 2.4 JTD oil leak: vacuum pump seal on the cylinder head
- Lancia Thesis engine surging between 1500 and 2000 rpm: ECU software
Lancia Thesis electric parking brake: EPB failure warning
Symptoms
The electric parking brake (EPB) warning light comes on with a failure message in the instrument panel, sometimes together with a VDC (stability control) warning.
Cause
Lancia service news bulletins give two causes on the Thesis. Bulletin 33.01.03 covers an EPB-VDC failure warning caused by the steering angle sensor wiring being pinched by the steering column cover. Bulletin 10.04.03 covers an EPB failure warning caused by the clutch pedal switch sticking or working irregularly. Both were corrected in production at Mirafiori.
Fix
Read the fault codes first to see which system has logged the fault. For the steering angle sensor, remove the steering column cover and secure the sensor and immobiliser aerial wiring to the steering column switch unit's junction with a strip band, clear of the cover, as the Lancia Thesis EPB bulletin shows. For the clutch pedal switch, fit the improved switch, identified by a white paint mark, as the clutch pedal switch bulletin describes. Clear the codes and test the parking brake afterwards.
Repair instructions on this site
- Service news 33.01.03: steering angle sensor, EPB-VDC failure warning (Thesis)
- Service news 10.04.03: clutch pedal switch, EPB failure warning (Thesis)
Sources: Lancia service news bulletins 33.01.03 and 10.04.03.
Lancia Thesis battery drain: flat battery after standing
Symptoms
The battery is flat after the car has been left unused for a long time.
Cause
Lancia service news 55.12.04 covers the Thesis. The door wiring nodes and the junction unit in the boot (the digital network junction unit) keep receiving power after the ignition has been switched off, slowly draining the battery. In production, the driver's and passenger's front door electric window switches and their control unit were modified.
Fix
Measure the battery's standing current drain first, following the separate Lancia bulletin on battery run-down, to confirm the fault. The Lancia Thesis battery drain bulletin then replaces the front door electric window switches and the junction unit in the boot. On the earliest cars (before chassis 4779) it also replaces further parts listed in the bulletin. Charge the battery fully afterwards, or replace it if it has been damaged by repeated deep discharge.
Repair instructions on this site
- Service news 55.12.04: door and boot wiring nodes, battery run down (Thesis)
- Thesis workshop manual contents
Sources: Lancia service news bulletin 55.12.04.
Lancia Thesis 2.4 JTD oil leak: vacuum pump seal on the cylinder head
Symptoms
Oil leaking from where the vacuum pump (the brake servo vacuum unit) is fitted to the cylinder head on the 2.4 JTD diesel, with oil collecting on the engine below it.
Cause
Lancia service news 33.02.03 covers the Thesis 2.4 JTD 10V and 20V. The bolts holding the vacuum unit lose their tightening torque as its seal beds in, and there may also be a ridge at the joint of the camshaft housing where the vacuum unit flange sits. From October 2002 production, Lancia improved how the parts were fitted, used a new seal and changed the order the fixing bolts are tightened in.
Fix
Clean all traces of oil from the engine around the vacuum unit so the leak can be confirmed. Then remove the vacuum unit, fit the improved seal and tighten the fixing bolts in the new order and to the torque given in the Lancia Thesis 2.4 JTD oil leak bulletin. Check for leaks after a road test.
Repair instructions on this site
Sources: Lancia service news bulletin 33.02.03.
Lancia Thesis engine surging between 1500 and 2000 rpm: ECU software
Symptoms
The engine runs unevenly, surging under light acceleration between about 1500 and 2000 rpm, and the climate control may not work as well as it should.
Cause
Lancia service news 10.07.04 covers the Thesis with both manual and automatic gearboxes. Certain functions in the injection control unit's software cause the uneven running. Lancia updated the software with new settings in production.
Fix
Rule out other causes first: read the fault codes and check for air leaks in the intake and for faulty sensors. If none are found, a dealer or specialist with the right diagnostic equipment reprograms the injection control unit with the updated software, as the Lancia Thesis engine surging bulletin describes. Road test afterwards to confirm the surging has gone and the climate control works properly.
Repair instructions on this site
- Service news 10.07.04: injection control unit, uneven running between 1500 and 2000 rpm (Thesis)
- Thesis workshop manual contents
Sources: Lancia service news bulletin 10.07.04.
Repair instructions for every Lancia model: Lancia workshop manuals