E.G.R. VALVE - R.R.

Operation 1080C74 · MOTOR FOR EGR VALVE SELF-ADJUSTMENT - R.R.

2.4 JTD 10V

Removing

See in Op. 1016A10

- Disconnect the negative battery terminal.

1. Undo the bolts fixing the expansion joint to the EGR valve.

2. Undo the bolts and the nut fixing the EGR valve to the intake manifold.

3. Disconnect the electrical connection for the EGR valve actuator.

4. Remove the EGR valve from the engine compartment.

Refitting

- Fit the EGR valve in the housing on the intake manifold.

- Tighten the nut and the bolts to torque.

- Connect the electrical connection for the EGR valve actuator.

- Tighten the bolts fixing the expansion joint to the EGR valve to torque.

See in Op. 1016A10

- Connect the negative battery terminal.

2.4 JTD 20V

Removing

See in Op. 1016A10 SOUND-PROOFING COVER - R.R.

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

- Disconnect the negative battery terminal.

1. Disconnect the EGR electrical connection.

2. Undo the bolts securing the EGR pipe to the heat exchanger.

3. Undo the bolts fixing the EGR valve to the intake manifold.

4. Remove the EGR solenoid valve.

- Recover the underlying gasket.

Refitting

1. Fit the E.G.R. system solenoid valve (1a) complete with seal and secure it tightening the bolts (1b) to the recommended torque.

2. Tighten the bolts fixing the exhaust gas recirculation pipe to the EGR solenoid valve to torque.

3. Connect the EGR electrical connection.

See in Op. 7040D50 ENGINE COMPARTMENT UPPER SOUND INSULATION SHIELD - R.R.

See in Op. 1016A10 SOUND-PROOFING COVER - R.R.

- Connect the negative battery terminal.