Workshop Manuals Factory service & repair Lancia
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Service news bulletins24 Special tools
Lancia Thesis Factory Service Manual (2002-2009)22 · Fault diagnosis
22 · Diagnostics

Vehicle drift

Make
Lancia
Model
Thesis Factory Service Manual
Year
2002–2009
Section
STEERING – vehicle behaviour › Vehicle drift
Fault diagnosisVehicle drift

VEHICLE DRIFT

The vehicle tends to drift to the left and/or the right whilst driving in a straight line

STEPOPERATIONS TO BE CARRIED OUTTEST RESULTS
0PRELIMINARY CHECKSALL OKPROBLEMS ENCOUNTEREDACTION

Check:

  • the condition of the tyres and inflation pressure;
  • that the wheels rotate freely;
  • visually inspect the underbody checking that there is no damage and the suspension components are working properly
  • the condition of the suspension flexible mountings
  • the condition of the steering components
Move on to Step1. Irregular tyre wear1. Replace the tyres and balance the wheels
2. Wheels braked2. Check the state of the bearings, hubs and calipers. If necessary, replace the components involved
3.Presence of distortions3. Replace the components involved
4. Supports damaged4. Replace the components involved
5. Components damaged5. Replace the components involved
1WHEEL GEOMETRY CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check the front and rear wheel geometryMove on to Step1. Front geometry irregular

1. Restore the correct front geometry

See in Op. 4450A10 FRONT WHEEL GEOMETRY - Check using optical equipment - Includes front wheel toe-in adjustment if necessary

2. Rear geometry irregular

2. Restore the correct rear geometry

See in Op. 4450A40 REAR WHEEL GEOMETRY - Check using optical equipment - Includes rear wheel toe-in adjustment if necessary

2DRIFT CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Test the vehicle along a straight line on a road surface in good conditions with no wind and check that there is no driftThe vehicle driftsSwap the front wheels roundMove on to Step
3DRIFT CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Test the vehicle along a straight line on a road surface in good conditions with no wind and check that there is no drift1. If the direction of the drift is reversed1. Replace the front tyresMove on to Step
2. The vehicle continues to drift in the same direction2. Swap the rear wheels roundMove on to Step
4DRIFT CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Test the vehicle along a straight line on a road surface in good conditions with no wind and check that there is no longer any driftingMove on to Step1. If the direction of the drift is reversed1. Replace the rear tyres
2. The vehicle continues to drift in the same direction

2. Overhaul the differential unit

See in Op. 2110D10 Differential INTERNAL CASING - R.R. with manual gearbox removed - Includes dismantling and reassembly of the gearbox

5CHECK ON CORRECT OPERATIONALL OKPROBLEMS ENCOUNTEREDACTION
Check that the fault is no longer present

Parts & tools for this job For 2002 Lancia Thesis

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.