Vacuum pipe for brake servo - r+r

Operation 3330D24 · Brake vacuum system

1.2 8v

Removing

1. Disconnect the brake servo single-acting valve from the brake servo.

2. Disconnect the vacuum pipe for the brake servo from the air chamber.

3. Release the vacuum pipe for the brake servo from the retaining band.

4. Remove the brake servo single-acting valve and the vacuum pipe.

1.2 16v, 1.4 16v

Removing

1. Disconnect the brake servo single-acting valve from the brake servo.

2. Release the vacuum pipe for the brake servo (2a) from the retaining band (2b).

1.3 JTD

Removing

The vacuum pipe and brake servo one-way valve are supplied as a single component from Parts and cannot be broken down individually.

Proceed with removal - 5530B10 battery - r+r.

1. Disconnect the electrical connection from the air flow meter.

2. Loosen the band and disconnect the the turbocharger air inlet sleeve from the rigid pipe, air flow meter side.

1.2 8v

Refitting

Refit the brake servo single-acting valve and vacuum pipe.

Secure the vacuum pipe for the brake servo to the securing band.

Connect the vacuum pipe for the brake servo to the air chamber.

Connect the brake servo one-way valve to the brake servo.

1.2 16v, 1.4 16v

1. Disconnect the vacuum pipe for the brake servo from the air chamber.

1.3 JTD

1. Remove the air filter (1a) complete with air flow meter (1b) by releasing from the underlying pins and then from the rear fastenings.

1.2 16v, 1.4 16v

Remove the brake servo single-acting valve and the vacuum pipe.

1.3 JTD

1. Disconnect the brake servo single-acting valve from the brake servo.

1.2 16v, 1.4 16v

Refitting

Refit the brake servo single-acting valve and vacuum pipe.

Connect the vacuum pipe for the brake servo to the air chamber.

Secure the vacuum pipe for the brake servo to the securing band.

Connect the brake servo one-way valve to the brake servo.

1.3 JTD

1. Disconnect the vacuum pipe for the brake servo from the vacuum unit.

2. Remove the vacuum pipe (2a) with one-way valve by releasing from fastening (2b).

Refitting

Refit the brake servo single-acting valve and vacuum pipe.

Connect the vacuum pipe for the brake servo to the vacuum unit.

Connect the brake servo one-way valve to the brake servo.

Replace the air filter, complete with air flow meter, in its housing.

Connect the air intake sleeve to the turbocharger, air flow meter side, and tighten the band.

Connect the electrical connection to the air flow meter.

Proceed with refitting - 5530B10 battery - r+r.