System test

SYSTEM TEST

1. Place the vehicle in a ventilated, shaded area free from excessive draught, with the doors and windows open.
2. Check that the surface of the condenser is not restricted with dirt, leaves, flies, etc. Do not neglect to check the surface between the condenser and the radiator. Clean as necessary.
3. Switch on the ignition and the air conditioner air flow control. Check that the blower is operating 10. Repeat at 1800 rev/min. efficiently at low, medium and high speeds. 11. Gradually increase the engine speed to the high Switch off the blower and the ignition.
4. Check that the evaporator drain tube is open and 12. Check for frosting on the service valves. clear. 13. Check the high pressure hoses and connections
5. Check the tension of the compressor driving belt, and adjust if necessary.
6. Inspect all connections for the presence of refrigerant oil. If oil is evident, check for leaks, 14. Switch off the air conditioning blower and stop and repair as necessary.
15. If the air conditioning equipment is still not

• NOTE: The compressor oil is soluble in
• Refrigerant R134a and is deposited when
• the refrigerant evaporates from a leak.

7. Start the engine.
8. Set the temperature controls to cold and switch the air conditioner blower control on and off several times, checking that the magnetic clutch on the compressor engages and releases each time.
9. With the temperature control at maximum cooling and the blower control at high speed, warm up the engine and fast idle at 1000 rev/min.

range and check the sight glass at intervals.

by hand for varying temperature. Low temperature indicates a restriction or blockage at that point.

the engine.

satisfactory, carry out a pressure test as previously described in this section.