300Tdi Discovery
4.0 V8
5
REPAIR
77. Release sensor/shield and remove.
78. Disconnect sensor multiplug.
79. Remove sensor.
80. Remove starter motor heatshield.
See
ELECTRICAL, Repair, Starter Motor
Heatshield - 4.0 V8
81. Disconnect solenoid Lucar.
82. Disconnect RH and LH knock sensor multiplugs.
See FUEL SYSTEM SFI, Repair, Knock
Sensor
83. Release harness from engine.
84. Remove nut securing handbrake cable
heatshield.
85. Release speed sensor lead from clip on
heatshield.
86. Remove heatshield.
87. Disconnect top oil cooler pipe union from
transmission.
88. Release union.
89. Remove ’O’ ring and discard.
90. Plug pipe and transmission.
91. Remove bolt securing oil cooler pipe bracket to
sump. Collect spacer.
92. Remove 3 bolts from top of bell housing.
93. Collect 2 harness brackets.
94. Remove 2 bolts, LH and RH side of bell housing.
95. Remove centre LH bell housing bolt using long
extension.
96. Remove 2 lower bolts from bell housing.
97. Fit suitable wooden block in access plate hole to
retain torque converter.
98. Secure block with cover plate and tighten one
cover plate bolt.
99. Support gearbox on a jack.
100. Lower ramp.
101. Position lifting chains and attach hooks to engine
lifting eyes.
102. Raise engine.
103. Raise jack.
104. Break engine to gearbox joint.
105. Raise engine.
