300Tdi Discovery
19
FUEL SYSTEM
16
REPAIR
ADD: 09/95
RELAY MODULE - ADVANCED EVAPS
Service repair no - 18.30.71
Remove
1. Release module from bracket.
2. Disconnect 2 multiplugs from module.
3. Remove module.
Refit
4. Position module, connect multiplugs and secure
to bracket.
FUEL FILTER - ADVANCED EVAPS
Service repair no - 19.25.02
Remove
WARNING: Spilling of fuel is unavoidable
during this operation. Ensure all
necessary precautions are taken to
prevent fire and explosion.
WARNING: Ensure fuel handling
precautions given in section 1 -
Introduction are strictly adhered to when
carrying out following instructions.
1. Depressurise fuel system.
See fuel system -
depressurise - advanced evaps
2. Raise rear of vehicle.
WARNING: Support on safety stands.
3. Clean area around hose connections to prevent
ingress of foreign matter into fuel system. Clamp
inlet and outlet hoses to prevent fuel spillage
when disconnecting hoses.
4. Loosen 2 fuel line unions and disconnect hoses.
Remove and discard ’O’ rings. Plug ends of
hoses to prevent ingress of dirt.
CAUTION: Use two spanners when
loosening or tightening unions.
5. Remove nut and bolt securing fuel filter bracket
to chassis and remove filter from bracket.
