300Tdi Discovery
SFI
19
REPAIR
ADD: 09/95
12. Using service tool LRT-19-009 loosen and
remove the metal locking ring.
13. Prise the pump from the tank opening using a
blunt instrument under the edge of the pump
flange. Once clear of the seal, tip the pump to
the right to allow fuel contained in the body of
the pump to drain into the tank.
CAUTION: Do not lift the pump from the
tank using the feed and return stubs.
14. Remove and discard seal.
Refit
15. Fit NEW pump seal to tank opening.
16. Carefully lower pump into tank opening, pressing
firmly on the pump top flange to allow correct
positioning.
NOTE: Ensure location tag on pump top
flange is engaged correctly to tank
opening lip.
17. Fit locking ring and tighten to
35 Nm using
service tool LRT-19-009.
18. Connect both fuel lines to the pump by pushing
the connectors down each line square to the
pump connection until the connectors positively
latch.
19. Connect vent hose to pressure sensor body.
20. Connect multiplugs to fuel pump and pressure
sensor.
21. Reconnect battery negative lead.
22. Refill tank with drained fuel.
23. Run the engine to check for any fuel leaks.
24. Fit access panel and secure with screws.
25. Reposition loadspace sound insulation and
carpet.
26. Fit RH luggage compartment side panel.
See
CHASSIS AND BODY, Repair, rear
compartment lower trim panels
27. Fit tail door tread strip and secure with screws.
