Land Rover 300Tdi Discovery Fuel Tank Repair | Advanced EVAP System
19
FUEL SYSTEM
20
REPAIR
ADD: 09/95
FUEL SYSTEM - DEPRESSURISE - ADVANCED
EVAPS
Service repair no - 19.50.02
WARNING: Fuel pressure of up to 2.5 bar
will be present in the system, even if the
engine has not been run for some time.
Always depressurise the system before
disconnecting any components in the fuel feed
line (between fuel pump and pressure regulator).
The spilling of fuel is unavoidable during this
operation. Ensure that all necessary precautions
are taken to prevent fire and explosion.
NOTE: Fuel pressure can be relieved at
fuel filter unions.
1. Position cloth around relevant union to protect
against fuel spray.
2. Carefully loosen union.
CAUTION: Use two spanners when
loosening or tightening unions.
3. Tighten union once fuel pressure is relieved.
4. Remove cloth.
FUEL TANK - ADVANCED EVAPS
Service repair no - 19.55.01
WARNING: Ensure fuel handling
precautions given in section 01
Introduction are strictly adhered to when
carrying out following instructions.
CAUTION: Before disconnecting any part
of fuel system, it imperative that all dust,
dirt and debris is removed from around
components to prevent ingress of foreign matter
into fuel system.
Remove
1. Disconnect battery negative lead.
2. Drain fuel tank completely.
See fuel tank -
draining - advanced evaps
3. Remove 6 screws securing tail door tread strip
and remove tread strip.
4. Remove RH luggage compartment side panel.
See CHASSIS AND BODY, Repair, rear
compartment lower trim panels