300Tdi Discovery
19
FUEL SYSTEM
12
REPAIR
12. Remove pin from pump gear.
13. Fit gear retaining tool LRT-12-045 with an 8 mm
washer, 1.5 to 2 mm thick, under each bolt head
in addition to the existing washer.
14. Remove throttle cable and hand throttle cable if
fitted.
15. Disconnect stop control solenoid connector.
16. Remove banjo bolts securing spill return, main
fuel and boost signal pipes, refit banjo bolts after
disconnecting pipes.
17. Remove pump mounting bracket bolts 2 off.
18. Loosen pump support bracket bolts to block,
sufficient for bracket to just move.
19. Remove pump securing nuts at flange and
withdraw pump and gasket.
20. Fit blanks to pipe connections.