300Tdi Discovery
Tdi
1
REPAIR
TANK SENDER UNIT
Service repair no - 88.25.32
WARNING: Ensure that the WARNINGS
and FUEL HANDLING PRECAUTIONS
given in Section 01 are adhered to before
carrying out the following operations.
Special tool - LST131
Remove
1. Disconnect battery negative lead.
2. Remove the rear carpet retainer.
3. Ease the carpet from under the lower trim panels
at the rear of the fold down seats.
4. Raise the carpet to expose the sound insulation.
5. Fold back the sound insulation to reveal the
access panel.
6. Remove the securing screws and detach the
access panel from the floor.
7. Disconnect the multi-plug from sender unit.
8. Disconnect the fuel pipes from the sender unit.
9. Using special tool LST131 remove the locking
ring and withdraw the sender unit from the fuel
tank.
Refit
10. Fit the sender unit to the fuel tank and secure
with the locking ring. Tighten to
45 to 50 Nm.
11. Connect the fuel pipes to the sender unit.
12. Connect multi-plug to sender unit.
13. Inspect the access panel seal to ensure that it is
satisfactory for further use, renew as necessary.
14. Fit the access panel to the aperture in the floor
and secure with the screws.
15. Reverse removal procedure. 1 to 5. Refit the
sound insulation and carpet.