300Tdi Discovery
SUPPLEMENTARY RESTRAINT SYSTEM
21
REPAIR
10. Press both operating buttons to deploy airbag
module.
11. DO NOT return to airbag module for 30 minutes.
12. Using gloves and face mask, remove airbag
module from tool, place airbag module in plastic
bag and seal bag.
13. Wipe down tool with damp cloth.
14. Transport deployed airbag module to designated
area for incineration.
NOTE: DO NOT transport airbag module in
the vehicle passenger compartment. DO
NOT re-use or salvage any parts of the
airbag system.
AIRBAG DIAGNOSTIC CONTROL UNIT - SPS SRS
Service repair no - 76.74.03
Remove
1. Remove centre console.
See CHASSIS AND
BODY, Repair, centre console.
2. Disconnect connector from control unit.
3. Remove 2 Torx bolts securing control unit to
body.
4. Remove control unit.
Refit
5. Position control unit to body, fit Torx bolts and
tighten to
10 Nm (7 lbf ft) .
6. Connect control unit connector and secure.
7. Fit centre console.
See CHASSIS AND BODY,
Repair, centre console.
8. Check supplementary restraint system using
TestBook.
